NT plant safety: guarding, isolation and changes of use
Plant risk management runs from purchase and installation through operation, cleaning, repair and disposal. The person controlling plant must address unauthorised interference and proper use; a new purpose requires a competent assessment of the associated risks. See chapter 3, especially pages 27–31.
Do not confuse stopping with isolation
A normal stop or emergency-stop button is not a substitute for controlling hazardous energy during maintenance. Review guarding, operational controls, emergency stops and isolation separately. Stored hydraulic, pneumatic, gravitational or other energy can remain after power is switched off. The code deals with these controls in chapter 4, including isolation at pages 44–46.
Guarding removed for cleaning or maintenance must be restored before normal operation. Review changes to the machine or its use rather than assuming the original assessment remains sufficient. Plant registration and operator high-risk work licensing are distinct questions: check each where relevant (chapters 3 and 5).
Workshop application
For a facility laundry or workshop, choose one machine and trace an ordinary cleaning job. Who disconnects and secures energy? How is restart prevented? Can someone reach a dangerous part? Who checks the guard before return to service? Compare the written procedure with observed practice, without assuming either is conclusive alone.
Retain the manufacturer’s instructions, commissioning evidence, maintenance history and modification decisions. Prioritise a known unsafe condition over completing the paperwork audit.
Status and limits
NT WorkSafe lists this code as varied on 12 March 2026. It is approved practical guidance; equivalent or higher-standard alternatives are possible. This guide does not determine the registration or licensing status of a particular machine. Verify its type, design and intended operation before deciding.

Comments