NT welding safety: fumes, radiation and hot-work risks need separate controls
A welding assessment must consider the process, consumables, base metal and surface coatings. Fumes are only one hazard: radiation, electrical shock, fire, compressed gases, burns and nearby workers also need attention (chapter 3).
Capture fumes, do not rely on an open door
The code distinguishes local exhaust from general dilution ventilation. It treats natural ventilation as unreliable for controlling welding fumes. Extraction needs to capture contamination near its source without directing it through the breathing zone or into other work areas. Screens that protect others from radiation can also change airflow. See section 4.1, pages 26–29.
Check electrical equipment, ignition sources, combustible materials and cylinders separately. Welding in a confined space brings additional entry and rescue requirements; a welding procedure alone does not satisfy them. PPE and equipment maintenance supplement the selected controls (sections 3.2–3.6, 3.9 and 4.2–4.3).
Facility maintenance example
Before repairing a fixture, ask whether the workpiece can safely be moved to a controlled workshop. If work must occur in place, identify adjacent occupants, combustible materials, access restrictions and the extraction route. Record who verifies the area is ready and who checks it afterwards. These questions do not establish that any particular repair was unsafe.
Collect the task assessment, material information, extraction checks, equipment inspections and any required permit. Do not use a generic “hot work approved” signature as a substitute for checking the actual work environment.
Status and limits
NT WorkSafe lists this code as varied on 14 September 2023. It is approved guidance. Check current exposure standards and any later legal changes rather than assuming numerical limits in a 2023 document remain current. This guide is not welding certification or a complete hot-work procedure.

Comments